DSG 6 DQ250 Mechatronic Repair (02E927770AQ / 02E325025AQ)

SKU TRA6964
  • 12-month warranty
  • Complete Mechatronic Unit
  • Part No: 02E 927 770 AQ / 02E 325 025 AQ
  • Fits Audi, Seat, Skoda, and VW models
  • Restores transmission functionality

From £749.00
Fast Turnaround 2-5 working days
Warranty Protection Covering all our repairs

Choose your service

★★★★★ “It’s good to have this gang on hand when it comes to gearbox electronics.” — Pawel P.

★★★★★ “Very professional , very prompt, well organised, thank you.” — Peter B.

★★★★★ “Good service on phone when ordering. Not able to say any more until part is fitted and see how it works!” — Eddie M.

★★★★★ “Had a part that was difficult to get hold of but they went the extra mile for a solution” — Johnathan M.

★★★★★ “Whole process of repairing my ABS module went smoothly without any issues. Staffs were friendly and professional. Will definitely use them again.” — zarif S.

★★★★★ “CU had great customer service and are very knowledgeable in what they do. Had a troublesome gear box mech which they sorted. Couldn't have been better to deal with. Highly recommend.” — Andy B.

DSG 6 DQ250 Mechatronic repair

12-month warranty2–5 day turnaroundTracked return deliveryRepair or replacement

Two ways to fix the DSG 6 DQ250 Mechatronic, fitted to Audi, Seat and Skoda models. Listed under part numbers 02E927770AQ and 02E325025AQ. Repair — send us your original unit, we strip and rebuild it and return the same unit, so it keeps the coding and security data already matched to your car and needs no programming (12-month warranty). Replacement — a brand-new unit with data transfer included; your original still has to be sent in so we can copy its coding and adaptation data across (12-month warranty). Both usually turn round in 2–5 working days.

Mechatronic units need basic settings and clutch adaptation with a diagnostic tool once refitted — that applies whether the unit was repaired or replaced. Any competent transmission specialist can do it; we tell you exactly what is needed with the unit.

Not sure the mechatronic is the cause? The symptoms and the fault codes we see on this unit are listed under Common Faults. If your codes differ, send them over before ordering — if the unit turns out not to be faulty you only pay the test fee and return postage.

Which vehicles does this mechatronic fit?

This unit is used across Audi, Seat, Skoda and Volkswagen. Check your exact model and year under Matching Vehicles, or compare the number printed on your own unit with the part numbers listed on this page. The same hardware often appears under several part numbers — call 01884 798090 if yours is not shown.

Prefer not to remove the unit yourself?

Choose the on-site option and bring the vehicle to our workshop in Uffculme, Devon. We remove, refit and road-test it before you drive away, usually the same day.

Part numbers

Part NumberPart NumberPart NumberPart Number
0D9300011L0D9300011M0D9300011N0D9300011P
0D9300011Q0D9300011R0D9300011S0D9300011T
0D93000120D9300012B0D9300012F0D9300012H
0D9300012J0D9300012K0D9300012L0D9300013A
0D9300013B0D9300013C0D9300013D0D9300020B
0D9300020C0D9300020D0D9300020G0D9300020J
0D9300020K0D93000400D9300040A0D9300040J
0D9300040K0D9300040L0D9300040N0D9300040P
0D9300040Q0D9300040R0D9300040S0D9300040T
0D93000410D9300041A0D9300041B0D9300041C
0D9300041H0D9300041J0D9300041K0D9300041N
0D9300041P0D9300041Q0D9300041R0D9300041S
0D9300041T0D9300042C0D9300042F

Frequently asked questions

Should I choose repair or replacement?

Repair is the usual choice: you get your own unit back with its coding intact and a longer warranty. A replacement makes sense when the unit is beyond economical repair — it is brand new, and your original still has to be sent in so we can transfer the data across.

How long will I be without the unit?

We aim to complete all repairs within 2–5 working days. Should a repair take longer, we will contact you with an update. It goes back to you on a tracked service. Ask about on-site fitting if you need the car back the same day.

My part number isn’t in the list — can you still help?

Usually yes. The same hardware appears under many part numbers. Send us a photo of the label or call 01884 798090 and we’ll confirm before you send anything.

What warranty do I get?

Repairs carry a 12-month warranty and replacement units 12 months. See Returns & Warranty for the full terms.

Does it need setting up after fitting?

Yes — basic settings and clutch adaptation have to be carried out with a diagnostic tool once the unit is back in the car. Fresh transmission fluid and a filter are strongly recommended at the same time.

Common Faults

What are the symptoms of a failing DSG 6 DQ250 Mechatronic mechatronic?

  • Jerking or slipping under load
  • Clutch adaptation failing after a service
  • Refusing to select a gear once the gearbox is hot
  • Pressure or solenoid fault codes stored in the transmission module
  • Gearbox dropping into limp mode
  • No communication possible with the ecu
  • CAN bus faults

Common fault codes

Fault code Meaning
P0701 Unit faulty
P0716 (VAG 17100) transmission input speed sensor (G182) implausible signal
P0722 (VAG 17106) Transmission Output Speed Sensor (G195): No Signal
P0731 (VAG 17115) gear 1 incorrect ratio
P0732 (VAG 17116) gear 2 incorrect ratio
P0733 (VAG 17117) gear 3 incorrect ratio
P0734 (VAG 17118) gear 4 incorrect ratio
P0735 (VAG 17119) gear 5 incorrect ratio
P0746 (VAG 17130) pressure control solenoid 1 (N215) short to earth /interruption
P0751 (VAG 17135) shift solenoid valve 1 (N88) short to earth/interruption
P0756 (VAG 17140) shift solenoid valve 2 (N89) short to earth/interruption
P0761 (VAG 17145) shift solenoid 3 (N90) short to ground/interruption
P0766 (VAG 17150) shift solenoid 4 (N91) short to ground/interruption
P0771 (VAG 17155) shift solenoid 5 (N92) – open or short to earth
P0776 (VAG 17160) Pressure control solenoid 2 (N216) short to earth /interruption
P1604 (VAG 18012) ecu defective
P1740 (VAG 18148) clutch temperature monitoring (G509)
P1746 (VAG 18154) supply voltage for solenoid valves
P1824 (VAG 18232) Pressure Control Valve 3 (N217): Open/Short to Earth
P1829 (VAG 18237) Pressure Control Valve 4 (N218): Open/Short to Earth
P1835 (VAG 18243) Pressure Control Valve 5 (N233) – Short to Plus
P2723 (VAG 19155) pressure control solenoid valve 5 (N233) short to earth/interruption
P2732 (VAG 19164) pressure control valve 6 (N371): short to earth/interruption

Seeing different codes, or not sure the mechatronic is the cause? Call 01884 798090 — we’ll check your codes and symptoms before you send anything.

Matching Vehicles

MakeModelYears
AudiA38L (1996-2003), 8P (2003-2008), 8V (2012-2020), 8Y (2020-present)
AudiQ2(2016-present)
AudiQ38U (2011-2018)
AudiS38P (2003-2013), 8V (2012-2020)
AudiTT8J (2007-2014)
SeatAlhambra1st gen (1996-2010), 2nd gen (2010-2020)
SeatAltea(2004-2015), (2008-2015)
SeatAteca(2016-present)
SeatLéon2nd gen Typ 1P (2005-2013), 3rd gen Typ 5F (2013-2020)
SkodaKodiaq1st gen (2016-present)
SkodaOctavia IITyp 1Z (2004-2013)
SkodaOctavia IIITyp 5E (2012-2020)
SkodaSuperb ITyp 3U (2001-2008)
SkodaSuperb IITyp 3T (2008-2015)
SkodaSuperb IIITyp 3V (2015-present)
SkodaYeti(2009-2017)
VolkswagenAtlas / Terramont(2017-present)
VolkswagenBora(2001-2006)
VolkswagenEos(2006-2016)
VolkswagenGolf V1K (2003-2009)
VolkswagenGolf VIA6 Typ 5K (2008-2013)
VolkswagenGolf VIIA7 Typ 5G (2012-2020)
VolkswagenJetta V / Bora / Golf Wagon / Vento / Sagitar(2008-2012), A5 Typ 1K (2005-2010)
VolkswagenJetta VIA6 Typ 1B (2010-2018)
VolkswagenNew Beetle(1998-2011)
VolkswagenPassat CCB6 (2008-2012)
VolkswagenPassat VB6 (2005-2010)
VolkswagenPassat V faceliftB7 (2010-2017)
VolkswagenScirocco III(2008-2017)
VolkswagenSharan II(2010-2022)
VolkswagenTiguan I(2007-2017)
VolkswagenTiguan II(2016-present)
VolkswagenTouran I(2003-2010)
VolkswagenTouran I facelift(2008-2012), (2010-2015)
VolkswagenTouran II(2015-present)

How It Works

  1. Place your order online — add the service you need to your basket. Before the item is added we ask for your vehicle details and fault codes, so we know exactly what we are working on.
  2. Send us your unit — replacements are supplied on an exchange basis, so we need your original unit to transfer its coding data. Prefer to program the new unit yourself? Order first and send your original afterwards.
  3. We do our part — we transfer your data to the new unit and test it, usually within 2–5 working days.
  4. Tracked return delivery — by DHL Express or DPD, ready for installation.

On-site fitting — choose the on-site option and call us to book a slot. We remove, repair and refit the unit while you wait (usually 2–3 hours) and road-test the car before you drive away.